IOMEGA JAZ BOOT DRIVE MAC SE SOFTWARE
a drive with a bumper or a better kind of bumper might better be able to prevent, say, media ripping, which means you could hypothetically recover from a future click of death by realizing your disks/media are misaligned, copy the data off them, LLF them with Iomega software on a good drive to refresh the format/alignment, then maintain the offending/failing disk, and perhaps add a bumper to it to prevent things from being problematic. I've seen some people claim that the presence/absence of bumpers makes certain problems better/worse (i.e. It wouldn't surprise me if, say, aging/failing power supplies was another cause for clicking, but I don't know how well documented that really is. The main fix was to copy data off the bad media and maintain or replace the improperly aligned drives. This specific error varied in severity and media that worked fine on one drive might not work in another. In general, the clicking is indicative of the drive being unable to sync properly to the media to read its contents, so one of the problems was media or heads that had fallen out of proper alignment.
The solution when this was happening 20+ years ago was to replace them, which, of course was easy to do because they were still being made, and probably made the problem worse because people were getting replacements based on updated cost-reduced designs that had worse problems to begin with.īy recollection (I need to research this at some point, even if that means finding my old posts on the topic) there were different causes for the clicking, some of which could be avoided in some way and some of which meant the drive and all media it had touched after a certain point were dead and would infect other drives. One noted that changing the power adapter on an external unit was sometimes successful. I'll post the links I found in case they might be beneficial to anyone:Īlso, another site had a short thread with discussion from people that had tried to repair their drives with varying success. In the meantime, I'm curious as to whether anyone else has found a fix for the click of death?
IOMEGA JAZ BOOT DRIVE MAC SE ZIP
I might have to dig out one of my deceased Zip 100 drives and take it apart to see. I did find a repair guide for the Zip 250, but whether that is applicable as well to the Zip 100, I don't know. (Plus, since the drive reader is the part seemingly most likely to be defective, there isn't an abundance of donor drives either.)
I did find instructions for replacing the disk reader, which is helpful from a disassembly point of view, but given that replacement drive readers aren't exactly available unless taken from a donor drive, that's not a practical repair solution in most cases. Question is, has anyone ever found a way to repair a drive that has succumbed to this? Searching online, I have not found anything. But, sometimes the drive itself succumbs and becomes unable to read Zip disks and might possibly damage good Zip disks to boot. I know from firsthand nearly extensive (unfortunately) experience that Iomega Zip 100 drives tend to eventually succumb to the dreaded "Click of Death." If you're lucky, if you can call it "lucky," only a Zip disk will be affected.
0 kommentar(er)
